Topic: Probleme beim umstig von 0.70 auf 0.8

Habe bis heute Version 0.70 verwendet.
Nach Installation der neuen Version Version 0.8 (DEV) / Windows 7, 8, 8.1, 10 (2020-09-23-2) musste ich feststellen, dass bei meinen Bauteilen die Labels für Spannung/Protokoll nicht mehr vorhanden sind. Diese können auch nicht mehr verwendet werden. Gibt es eine Möglichkeit diese wieder zu verwenden bzw. schnell umzustellen. Außerdem, funktioniert das Füllen und die Vergabe von neuen Farben bei Polygonen, Rechtecken usw. nicht mehr.

Post's attachments

Attachment icon Unterschide 0.7_0.8.png 964.07 kb, 81 downloads since 2020-09-23 

Re: Probleme beim umstig von 0.70 auf 0.8

See : https://qelectrotech.org/forum/viewtopi … 038#p13038

Great project I think, you could share it?

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

3 (edited by Calypso 2020-09-23 12:56:10)

Re: Probleme beim umstig von 0.70 auf 0.8

Hallo,
habe gerade mal ein älteres Projekt geöffnet, an den Folienverweisen fehlen die Angaben zu Spannung / Protokoll. Spannung / Protokoll variable ist nicht mehr vorhanden.

Stebo

Post's attachments

Screenshot_new.png, 23.33 kb, 357 x 564
Screenshot_new.png 23.33 kb, 169 downloads since 2020-09-23 

Re: Probleme beim umstig von 0.70 auf 0.8

Hallo Stebo,

tension/protocol variable was removed for element information widget, is only for conductors now.

https://git.tuxfamily.org/qet/qet.git/c … 0a7898e503

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

Re: Probleme beim umstig von 0.70 auf 0.8

Hello scorpio810,
ok but how can i use it when i select a conductor and enter something in the selection window under voltage / protocol nothing is displayed on the conductor.

Best regards

Stebo

Re: Probleme beim umstig von 0.70 auf 0.8

Like this?
https://download.qelectrotech.org/qet/forum_img_2/protocol.png

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."