Topic: Cross Reference Help

Good Morning!

Please, I´m using a Magneto Thermal Circuit Break and one NF and one NO auxiliary contact.
Honewever, when I do the Cross Refecerence (Link to the item), it´s show me two NF contacts. How I may correct it?

Second point.
I edited the label of the Circuit Break, and the texts of auxiliary contacts get wrong.

May I have help please.

Post's attachments

Capturar.JPG, 39.77 kb, 827 x 253
Capturar.JPG 39.77 kb, 65 downloads since 2023-06-27 

Re: Cross Reference Help

For the second point see this thread:
https://qelectrotech.org/forum/viewtopi … 451#p18451

Fragen zu QET gehören in dieses Forum und werden nicht per PM beantwortet! – Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !

Re: Cross Reference Help

About the wrong Xref (NC instead of NO) check the properties of the NO contact, the parameter of slave type is probably set to NC change it to NO in the element editor.

Développeur QElectroTech

Re: Cross Reference Help

Strange, I think you use a very old QET version?

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

Re: Cross Reference Help

scorpio810 wrote:

Strange, I think you use a very old QET version?

Hi I did a new download... Now I´m using V0.100.0-DEV.

I didn´t test yet, I will try.

Best Regards.