1 Topic by LievenC (edited by LievenC 2023-03-14 12:09:29)

  • LievenC
  • Membre
  • Offline

Topic: Master Slave reference

The cross reference for master slave shows the folio number instead of the folio label.
In the project settings cross reference I have set %F-%l%c for the master and (%F-%l%c) for the slave indication

where to change so that te cross reference shows the folio label (%F)

Post's attachments

Attachment icon untitled.qet 42.31 kb, 99 downloads since 2023-03-14 

Always using the latest development version

2 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Master Slave reference

Your folio label is 12
With %f it's show 1 because is the first folio
With %F is's show 12

Post's attachments

Attachment icon lievenc.qet 42.31 kb, 108 downloads since 2023-03-14 

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !

3 Reply by LievenC

  • LievenC
  • Membre
  • Offline

Re: Master Slave reference

Also found in mean time:
the setting for cross reference has to be done 3 times for each type of element

coil - organ of protection - switch/button

and this is what I had forgotten
it only worked for coil

Always using the latest development version

4 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Master Slave reference

Sure, you have 3 enities "coil", "organ of protection", and "switch/button" settings to configure differently.

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !