1 Topic by LievenC (edited by LievenC 2023-03-14 12:09:29)

Topic: Master Slave reference

The cross reference for master slave shows the folio number instead of the folio label.
In the project settings cross reference I have set %F-%l%c for the master and (%F-%l%c) for the slave indication

where to change so that te cross reference shows the folio label (%F)

Post's attachments

Attachment icon untitled.qet 42.31 kb, 87 downloads since 2023-03-14 

Always using the latest development version
  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Master Slave reference

Your folio label is 12
With %f it's show 1 because is the first folio
With %F is's show 12

Post's attachments

Attachment icon lievenc.qet 42.31 kb, 97 downloads since 2023-03-14 

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

Re: Master Slave reference

Also found in mean time:
the setting for cross reference has to be done 3 times for each type of element

coil - organ of protection - switch/button

and this is what I had forgotten
it only worked for coil

Always using the latest development version
  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Master Slave reference

Sure, you have 3 enities "coil", "organ of protection", and "switch/button" settings to configure differently.

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."