1 Topic by gravino

  • gravino
  • Nouveau membre
  • Offline

Topic: Folio number

hy every one

in my project i would like to put my elemnts in specific number folio

example motors and driver from folio 6 untill 19

input PLC from 20 to 29

so i need to give ofset to new page or add empty page because in crossreference i can't use the that i give to my page

can someone help me pleas

Best regards

Gravino

2 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Folio number

Hi Gravino,

in project setting or in general config enable use folio number/label instead of their position ...

https://download.qelectrotech.org/qet/m … oject.html

Use %F instead %f in formula for crossreference, reports, etc.
https://download.qelectrotech.org/qet/m … tings.html
https://download.qelectrotech.org/qet/m … tings.html


Best regards,
Laurent

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !

3 Reply by gravino

  • gravino
  • Nouveau membre
  • Offline

Re: Folio number

Hi Scoprpio,

thank you very much voor your help, you guys are doing a great job, i'm learning now to use QET it's powerfull

4 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Folio number

Hi,

btw use "%id" instead  "%id/%total" in your titleblock's pages, otherwise you will see Xref like this "(folio_label/total_ off_folios)-(line number)- (column_number) etc.

So, is easy with ctrl +f in and then folio section to change "%id/%total" by "%id" in all project's.

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !