Topic: QElectroTech craches

I am using QElectroTech V 0.70-dev+svn5495.
When QElectroTech is open and I doubleclick a file ....qet,the program crashes without a message. It just disappears. When I open QElectroTech again a message appears that a repair file exist and if I want to open it.

2 (edited by Morganol 2018-09-04 13:14:45)

Re: QElectroTech craches

Can you tell us a bit of what system you use?

If you start it from command line, is there any messages when it crashes?


Edit: Oh by the way:
Welcome to the club nomicons/smile
 /Edit

Re: QElectroTech craches

When QElectroTech is open and I doubleclick a file ...

If QET is already open the good way to open an project is by menu file -> Open, or latest files.

Thanks for report this issue, this no work here on my Debian machine but no crasche QET, is not open the file...

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

Re: QElectroTech craches

Morganol wrote:

Can you tell us a bit of what system you use?

My system is: Windows 10 Home, Version 1803, Build 17134.228.

If you start it from command line, is there any messages when it crashes?

No message at all. It just stops.

Oh by the way:
Welcome to the club 20x20

Thanks.

If QET is already open the good way to open an project is by menu file -> Open, or latest files.

Indeed that is the way I normally do it. But I had a situation where i found it easier to just doubleclik the files I wanted to open.

Re: QElectroTech craches

 i found it easier to just doubleclik the files I wanted to open.

So do not launch QET before. 
Simply doubleclik  on the file launch QET and your project/element/titleblock in the right editor.

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."