1 Topic by becrazy

  • becrazy
  • Nouveau membre
  • Offline

Topic: Creation of new part with master/slave

Hello,

I am trying to generate a new part, which is an KNX actuator with 8 single output ports. The output ports are named A, B, C, ..., H. When I use the master/slave I will get the contacts connected to the master, but I would like to have the single contacts listed according to the channels A ... H, instead of list them under the part.
Is there a way to solve the problem?



Would be great to get this working.

Regards,
Benjamin

Post's attachments

Attachment icon example_knx_actuator.jpg 42.6 kb, 332 downloads since 2018-03-08 

2 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Creation of new part with master/slave

Hello,

https://qelectrotech.org/forum/viewtopi … 7811#p7811

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !