Re: QET-Element to SVG
Hello Erik,
as Joshua also explained in this Post (https://qelectrotech.org/forum/viewtopi … 180#p19180) (see above):
In QET we have the CheckBox "closed" for a Polygon. Then the Start- and End-Points of are connected.
In SVG there is no such attribute: There is "Polyline" for "open" and "Polygon" for "closed".
The Element you mentioned has some "open" polygons so that's why a "Polyline" must be used for SVG.
Can you explain, why you think "Polyline" may be wrong or "not good"?
EDIT:
If you think the "kink" in the dashed line is not properly recognizable, then I must refer you to the creator of this element: The drawing is not correct!
These kinks in the dashed lines represent a kind of "notch" for the actuation, which (since I have been working in electrical engineering) is shown with a solid line. Only the notch, not the rest of the mechanical connection of the switching elements! In the attachment you find a screenshot from "Eaton Schaltungsbuch 2023" PDF-Page 485 (https://www.eaton.com/de/de-de/support/ … sbuch.html)
Have we found a volunteer here who wants to fix this error in the elements, Erik?