1 Topic by Szusza

  • Szusza
  • Nouveau membre
  • Offline

Topic: Element wiring disorder/fault

Hi everyone. I am new to QElectrotech.

I need some other elements, so I thought I should draw. I wanted to match an existing element's contacts, so I copied from one to a new element page. When I wired them up in a circuit, I couldn't get straight wires from one contact to another, there is always a step in it.
Any ideas ?

Thank you for your help.

(I attached qet, bmp files to see it.)

Post's attachments

Attachment icon Ãšj bitkép (2).bmp 1.82 mb, 123 downloads since 2023-04-14 

Attachment icon Ãšj bitkép.bmp 1.3 mb, 101 downloads since 2023-04-14 

Attachment icon projekt.qet 45.19 kb, 130 downloads since 2023-04-14 

2 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Element wiring disorder/fault

Hi,

element terminals must be aligned with the element editor grid with a step of 10px.

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !

3 Reply by Szusza

  • Szusza
  • Nouveau membre
  • Offline

Re: Element wiring disorder/fault

Actually, I couldn't do it. How you do it ? Sorry for late response, I used another software, but I need to use QElectrotech again.

Thank you for your help.

Máté,

4 Reply by scorpio810

  • scorpio810
  • scorpio810
  • QElectroTech Team Manager, Developer, Packager
  • Offline

Re: Element wiring disorder/fault

Fixed, I edited second circuit breaker and moved all parts a little, re drag and drop, save and reopen project, voila.

Post's attachments

Attachment icon projekt.qet 44.5 kb, 98 downloads since 2023-08-22 

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !