1 Topic by mikea

  • mikea
  • Nouveau membre
  • Offline

Topic: grid settings and snap ?

Hi,
I can't seem to find any settings for the grid or snap in the element editor.
The problem I have is when I copy an element, all is ok when I paste it, but when I try to move them together they don't align anymore ? Sometimes it works, but only very seldom...
I am trying to create a 3P module component from an 1P.

2 Reply by achim

  • achim
  • Membre
  • Offline

Re: grid settings and snap ?

No, currently there is no way to set the grid in the ElementEditor

3 Reply by plc-user

  • plc-user
  • Moderator
  • Offline

Re: grid settings and snap ?

mikea wrote:

The problem I have is when I copy an element, all is ok when I paste it, but when I try to move them together they don't align anymore ? Sometimes it works, but only very seldom...

You are using an "old" version of QElectroTech!

In recent versions of 0.100-dev I reworked Copy-and-Paste for element-editor.
Now the paste-position for graphical primitives is much more reasonable!
You can also rotate, flip and mirror the graphical primitives in element-editor!
Give it a try!

Fragen zu QET gehören in dieses Forum und werden nicht per PM beantwortet! – Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !

4 Reply by mikea

  • mikea
  • Nouveau membre
  • Offline

Re: grid settings and snap ?

plc-user wrote:
mikea wrote:

The problem I have is when I copy an element, all is ok when I paste it, but when I try to move them together they don't align anymore ? Sometimes it works, but only very seldom...

You are using an "old" version of QElectroTech!

In recent versions of 0.100-dev I reworked Copy-and-Paste for element-editor.
Now the paste-position for graphical primitives is much more reasonable!
You can also rotate, flip and mirror the graphical primitives in element-editor!
Give it a try!

Thanks for the info, I'll test it asap tomorrow.