You are not logged in. Please login or register.
QElectroTech → EN : Help, suggestions, discussions, ... → XREF and nomenclature report
Hi community,
Not sure how to deal with slave symbols to be listed on nomenclature report.
I use slave symbols as master symbol accesories. As they must be purchased, I want them to be on my symbols (nomenclature) report when printed.
I can probably duplicate my slave symbol and create a master copy but I don't think it is the proper way.
Is there any way slave symbol can handle information as master and be included on reports?
Best regards, Josey.
By default, the slave elements do not have their own labelling as they are usually an integral part of the master element (relay contact etc.). I therefore assume that this is probably not possible at the moment.
A similar request came up some time ago: switches with knobs, push rods, etc., which must appear somewhere in the parts list, too.
Thanks bro.
I created a master symbol copy with all slave references on part number and label, so each setup can appear on reports.
Some schematics software/designers create a drawing parts sheet. I did a sheet for just a master symbol but it works.
Can you give a simple example of your art here so that others can benefit from it?
Thanks in advance!
Report:
https://ibb.co/71M54fB
Sheet:
https://ibb.co/Lvcf0xR
Report:
Sheet:
QElectroTech → EN : Help, suggestions, discussions, ... → XREF and nomenclature report
Powered by PunBB, supported by Informer Technologies, Inc.
Generated in 0.024 seconds (17% PHP - 83% DB) with 11 queries