Topic: Marcros

Hello all,

I try to import some Marcos that I downloaded for some parts that I use. I tried google a bit, but didn't find anything useful that wasn't at least 1 and a half years old. So I hoped there might been an update on importing Marcos? If not, how do I do that without the use of EPlan or Solidworks?

Re: Marcros

Use element-editor to create elements.
With dxf-importer you can import dxf into element-editor.
No other importers are implemented!

Fragen zu QET gehören in dieses Forum und werden nicht per PM beantwortet! – Questions regarding QET belong in this forum and will NOT be answered via PM! – Les questions concernant QET doivent être posées sur ce forum et ne seront pas traitées par MP !

3 Reply by marieprimmer874 (edited by marieprimmer874 2024-04-24 09:05:06)

Re: Marcros

plc-user wrote:

Use element-editor to create elements.
With dxf-importer you can import dxf into element-editor. geometry dash scratch
No other importers are implemented!

Thanks for your answer. This is what I am looking for