Topic: wire numbering

Hey! nomicons/smile

It is possible to make other wire numbering macro:

now i have %id for current page, fex: 66.21 (on page 66), if i'll connect this wire to element on page 72 right now all is correct on page 72 - 66.21, but on next opening project wire renumber as: 72.21 - i don't need it.

any ideas to make %sid (source id page), to allow numbering from 66 page only (but if i'll change pages: move, or insert new page save the %sid (move to 67 or 65)

and of course i dont need make fixed numbering like 66.21

nomicons/smile lots of words
TY a lot guys for understanding, support and amazing software!