Topic: auto numbering

I have to use qelectrotech to make a quite big project, so I am tryin to find the best setting. I would like to usi automatin numbering  of conductors and elements. I set the option to have N°of page followed by two progressive numbers. I am used to make the progressive number to start for every folio, in order to avoid too long numbers, but I am not albe to provide this setting. The number of conductors start from 0 in the first folio and continue to grow, despite the fact the diffrent prefix could allow to restart in each folio. Is there any way to make the number restart in each folio?

Re: auto numbering

Enable this rules at all folios, and draw conductors, the wire numbering is start to 1 through folio.
https://download.qelectrotech.org/qet/forum_img_2/autonum_number_folio.png

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

Re: auto numbering

Please make warning if you link by reports yours conductors:
https://qelectrotech.org/forum/viewtopi … 88&p=2

"Le jour où tu découvres le Libre, tu sais que tu ne pourras jamais plus revenir en arrière..."

Re: auto numbering

Thank you very much! at the end I decide to numbering wires manually, as you wrote numbering related to folio is a problem.