Hello Everyone,I have a problem with crossing adress of e.g. auxiliary contact of motor breaker. The cross address position is the same as the name of breaker. Could you tell me how did you deal with this problem? Below is a photo.
Thanks!
1 2019-09-30 12:50:23
Topic: Problem with patch address (0 replies, posted in EN : Help, suggestions, discussions, ...)
2 2019-09-23 08:09:52
Re: A few questions about QET (4 replies, posted in EN : Help, suggestions, discussions, ...)
scorpio810 wrote:
Hello,
Thanks for compliments.
1. is only a demo not added yet.
2. you can but with a lot of workaround, see in forums.
3. Project-> export csv. I you have added in all elements informations in the widget off course.Cheers,
Laurent
Thank's!
Could You tell me which version of QET is better? Version 0.70 orz 0.70 (DEV) ? Because i have a problem with polish language translate (it doesnt polish all words in program e.g. menu)
Best regards,
Jacek
3 2019-09-22 13:06:34
Topic: A few questions about QET (4 replies, posted in EN : Help, suggestions, discussions, ...)
Hello
Everyone!
In the beginning I would like to thank you for the work you did to
createthe program.
I likethe program very much and it is intuitive.
I wouldlike to ask a few questions that I didn't find theanswer to in the forum. I'm using the following version of the program: QElectroTech V 0.80-DEV.
1. Isthere an option to automatically generate cables when drawing lines? I used the instructions on the forum and unfortunately it doesn't work. (like in this link download.qelectrotech.org/qet/joshua/Cable.webm with generate name of cable) Ican't run this function
2. CanI use Crossing addresses in the program to use in the PLC I / O?
3. Howcan I make a valid list of materials?
Thankyouin advance for your help and answers